Very thin film could help manage heat flow in future devices

Purdue University researchers have demonstrated the ability of a thin film to conduct heat on just its surfaces, identifying a potential solution to overheating in electronic devices such as phones and computers.

"When you try to make an electronic device, the heat dissipation is always a problem," said Xianfan Xu, Purdue's James J. and Carol L. Shuttleworth Professor of Mechanical Engineering. "So we are trying to provide an understanding of how heat can be dissipated in these future devices."

This thin film material is a topological insulator, which supports the flow of electrons on its surface but not in its interior. No study had yet tested whether the same were true for heat, until confirmed by research published on Jan. 23 in ACS Nano. Past research has speculated that topological insulators could be useful for the development of spintronic devices, which encode information through the spins of electrons as opposed to electrical charge in today's electronics.

The researchers found that the thinner the film is, the higher the heat conductivity. They also discovered that the ratio of thermal conductivity to electrical conductivity at the surface of the topological insulator materials can be more than 10 times higher than the Sommerfeld value, which is the value known for most metals and semiconductors determined by the Weidemann-Franz law. By conducting heat on just its surfaces rather than across the entire film, this material could prevent parts of a device from heating up or redirect heat.

Now, having identified this characteristic of heat transfer in topological insulators, the next step is to figure out how to use them for manipulating heat flow.

"There are not many ways to control heat. It's not electricity, where you can turn it on and off," Xu said. "But now there might be a chance to do that."