Researchers integrate diamond/boron nitride crystalline layers for use in high-power devices
Materials researchers at North Carolina State University have developed a new technique to deposit diamond on the surface of cubic boron nitride (c-BN), integrating the two materials into a single crystalline structure.
"This could be used to create high-power devices, such as the solid state transformers needed to create the next generation 'smart' power grid," says Jay Narayan, the John C. Fan Distinguished Chair Professor of Materials Science and Engineering at NC State and lead author of a paper describing the research.
"It could also be used to create cutting tools, high-speed machining and deep sea drilling equipment," Narayan says. "Diamond is hard, but it tends to oxidize, transforming into graphite – which is softer. A coating of c-BN would prevent oxidation. Diamond also interacts with iron, making it difficult to use with steel tools. Again, c-BN would address the problem."
C-BN is a form of boron nitride that has a cubic crystalline structure. It has similar properties to diamond, but holds several advantages: c-BN has a higher bandgap, which is attractive for use in high-power devices; c-BN can be "doped" to give it positively- and negatively-charged layers, which means it could be used to make transistors; and it forms a stable oxide layer on its surface when exposed to oxygen, making it stable at high temperatures. Earlier this year, Narayan unveiled a faster, less expensive technique for creating c-BN.
To create the epitaxial, or single crystal, diamond/c-BN structures, the researchers begin by creating a substrate of c-BN. This is done using the new technique Narayan published earlier this year. They then use a process called pulse-laser deposition – which is done at 500 degrees Celsius and an optimized atmospheric pressure – to deposit diamond on the surface of the c-BN. The pulse-laser technique allows them to control the thickness of the diamond layer.
"This is all done in a single chamber, making the process more energy- and time-efficient," Narayan says. "You use only solid state carbon and BN, and it's more environmentally benign than conventional techniques."
The researchers were also able to deposit diamond on the c-BN using the conventional chemical vapor deposition technique, which utilizes methane gas, hydrogen gas and a tungsten filament at 900 °C.
"The chemical vapor deposition approach works, but our pulsed laser deposition approach works much better, doesn't involve toxic gases, and can be done at much lower temperatures," Narayan says.
More information: Jagdish Narayan et al. Direct conversion of h-BN into c-BN and formation of epitaxial c-BN/diamond heterostructures, Journal of Applied Physics (2016). DOI: 10.1063/1.4948688
Journal information: Journal of Applied Physics
Provided by North Carolina State University